stub out

I cut the four inch PVC down to where the toilet flange would be at finished floor level but it won’t go down into the pipe. It only goes in about 5/8”. I was thinking of cutting it down to where inserting about that far would leave me at finished floor level and epoxing it in for strength. Is...

I know I've seen it done before, and the 1/2" PEX supply lines fit tight in the copper Holdrite straps, but is it correct or permissible? If it is, should they be secured through the strap in some way? Brass PEX 90's in the wall to make the turn into the straps. I know they make larger holed...

Anyone had this happen? Attempting to unclog my bathroom sink drain by removing trap. In doing so, the glued in, and brittle horizontal ABS pipe connecting the trap to the sanitary tee in the drainline broke off. It looks like I need to either: - cut out the tee and plumb a new one back in, or...

Hi all, I installed a new vanity in the bathroom and am replacing the p trap to the new sink. I might be using the wrong terms so please bear with me. The current setup is a stub out made of metal. Attached to that is a black PVC trap arm. The part that angles down to the p trap is flared...

Hello all! I'm brand new to the forum and a DIYer (at best). The best/closest info I could find on the web regarding a situation like mine was from y'all's forum - thanks. Info - location St. Louis House build date 1936 - plumbing update - unknown I went to put in a new vanity/sink and when...