instalation

I cut the four inch PVC down to where the toilet flange would be at finished floor level but it won’t go down into the pipe. It only goes in about 5/8”. I was thinking of cutting it down to where inserting about that far would leave me at finished floor level and epoxing it in for strength. Is...

Hello, I am new to this forum and looking for some advice on choosing and installing a water softener; as well as a carbon filter for chlorine and a RO system sometime down the line. Let me apologize in advance for my lack of understanding in the subject and say that I greatly appreciate any...

Kohler K-45904 HydroRail® installation A nice way to allow height adjustments for a shower. The shower arm is replaced and 1/2" holes drilled for the mounting. I picked up a diamond bit for this. The lower attachment holes. Stuff in the box. One side in. Both side in.

Here was a disposer leak at the connection between the disposer rubber seal and the basket, caused by the installer not seating the snap ring in the groove. You can see on the right side the snap ring sticking out, and on the left how it's hidden. Everything looked fine to the handyman that...

A new deeper undermount sink for the kitchen, and the existing piping under the sink is too high and too strange. It's time for a plumbing hack. It's looking a little strange, but let's take a better look. Two short 90's before the p-trap. The homeowner never like snaking that mess...