Search results

Hello, I'm working on installing a toilet in my basement. Well when they roughed in my toilet drain they were not careful to make sure the bolts would be 12" from the wall. The center of my flange installed with the rough in) is now about 1" offset from the center of my toilet hole. My...

I'm having trouble with my sump pump. It is running continuously and not pumping out any water. I checked the float and it is all the way raised as there is sufficient water in the pit to raise the float. However no water is being ejected from the pit. The float is fully operational. When I...

I have to cut out a hole in my three piece fiberglass shower for the faucet. Is there a standard size the cutout should be? I think I remember seeing that the hole should be 4.5" (large enough for the faucet but small enough that the trim plate covers it).

Hello, I am finishing a basement bathroom. I have done all of the dry fitting for my copper piping. I'm debating whether or not I should finish the job and do the soldering myself or if I should hire that work out to a professional plumber. Does anyone have any idea of what a plumber would...

have a question on installing a trap for a basement shower. The basement was rouged in for a shower. There is a 12" x 12" dap out with a 2" drain pipe. However the dap out is very close to the ground and in a corner of the dap out. In order to center the drain with the hole in the shower...

Hello, I'm fairly new to plumbing and am attempting to finish off a basement bathroom. The vent/waste system was roughed in during construction of the home. A dap out was left for the shower drain. It was not trapped and only a stub of 2" pvc protrudes into the dap out space. The drain...