Search results

  1. MooseMan

    Dual Fuel Calculator (Trane)

    Picking up off a previous thread: System is a Trane: XC95M Furnace, XV20i Heat Pump, and XL1050 Control. I'm trying to understand how heat pump to propane cutover works. -By default, Compressor Heat Lockout was disabled. At 20 degrees, it sounds like an airplane. -In activating Compressor...
  2. MooseMan

    Zone Sizing & Clamp LV settings (Trane)

    Entering our first winter in the northeast with a multizone dual fuel heating system. System is a Trane: XC95M Furnace, XV20i Heat Pump, and XL1050 Control. The heat pump has been fantastic, but now that its colder I'm curious about efficiency, cutover, and NOISE. Right now it is 20 degrees out...
  3. MooseMan

    Hot water air bubbles after o3 install

    I draw water from a lake. Recently, we had a whole house filtration / purification system installed (o3 generator, softener, UV lamp), including an RO system under the sink. Water is amazing. But immediately after, I started getting air in the hot water line only. After some reading, I flushed...
  4. MooseMan

    Preventing water pipe freeze at lake

    Hi - we have a camp in the Adirondacks which we use occasionally during the winter. When we leave, we drain it, and open the main supply valve to let the water drain back to the lake (the pump is a submersible in the lake). Last winter, we couldn't get the water back up to the camp again. So -...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks