Search results

OK....I'm installing the shower pipes and I have been anchoring the pipes with the copper "U" shaped pipe holders to wood blocks that are screwed to the studs or sill plates. This is so I don't get rattles & other noise when turning the shower faucet on and off. I notice, though, that if I...

Hi Folks, I'm doing a remodel and have done all the joint sweats for the first time myself. I've been lucky so far....over 40 joints and no leaks. I have run into a few now where I can't do them on the bench and the joints are upside down. The solder will have to go UP into the joint. Will...

Hi Again Folks....My second question. The Moen shower control I am installing recommends that the shower drop ear elbow that holds the shower head nipple should be 78" above the floor. I'm assumming that they mean above the shower floor. Anyway...the owners of the house are short and the...

Hi Folks...My first post. I am installing a Moen Posi-Temp L82680 shower control in a remodel and I need to know how and where to install the air chambers. I've never done it with a single mixing valve before. I think I would just install a vertical "T" fitting at the ends of the short pipes...