Search results

Hi all, have a basement bath remodel going on. The following picture illustrates the existing basement bathroom drains, which are labeled. I am moving the shower drain (2") about five feet from its existing location (farther away from the vent), which consequently makes it so the original vent...

I'm looking for a 45 degree reducing wye; 4x4x3, with hubs on the top (inflow) 4 inch and side 3 inch connections and a 4 inch spigot on the downflow end. Same for a 3x3x2. I attached a drawing for reference sake. I can't find these at any major home center. It looks like Nibco may make them...

I have a small basement bathroom on a concrete slab. the existing toilet has a 10 inch rough in drain. The front of the toilet is too close to the shower and the wall. Does a corner toilet with a ten-inch rough in exist? I'd rather not have to break up concrete and move the drain. Thanks...

I'm adding a subpanel in an attached garage, adjacent to living space, a common wall. I'm in unincorporated Snohomish County. what are the rules regarding placing a subpanel in an attached garage, in or on a common wall with adjacent living space? Thanks!

I'm in a bit of a bind. I've been in the process of installing a new copper water main (one inch type L soft) from the meter to the house. the line is laid, but the copper tubing at the meter end is slightly oblong, not round. After screwing around with it and attempting to sweat it four times...

Ok, installing 1 inch type L soft for a new service line between the meter and the house. I want to sleeve the line in something to protect it from roots and rocks. I can't do rigid PVC because it's not a straight shot. Would corrugated flexible plastic drain pipe work ok? I read...

I'm in Bothell, WA, currently replacing the main between the meter and house. I plan to use type L soft copper, probably sleeved with some closed cell foam. The run is about 70ish feet, with a couple of bends; up a rise and around the foundation. Is an expansion loop necessary? or will the...

Hi! Well, I've got a leak in the main between the meter and the house. The existing main is in an unknown region of a vast front yard and I've begun to trench for a new line. I plan to install type k soft copper and I have to make three bends to overcome a small rise between the meter and...