Search results

Hello everyone, Several weeks back I became suspicious that hard water had entered our system and I went back to check the settings--several of my settings had changed back to default. For example the reserve capacity (which was at 200g) was set back to 0. I also noticed that the timings...

Quick question about they way I plumbed my softener: The main line that feeds the softener tees off to an outside water faucet (just a few feet before reaching the softener) so that I don't get softened water through my outdoor hose. When I run the hose, the meter on the water softener...

I've just finished installing my 2510SXT and need to get the programming set up for efficient potassium chloride use. Total Hardness = 11 No Iron (city water) Two adults 1.5 cu ft system BLFC = .5gpm What should I set the following parameters to? Unit Capacity Safety Factor Day...

Quick question: I'm installing a new 2510 water softener and after filling the media tank with resin I put the control valve on. After doing so, I remembered that I should fill the tank with water to reduce the amount of air in the lines when the system goes live. I removed the control...

I'm installing a water softener in the garage. The house is plumbed with PEX pipe and crimped fittings. Here is my question: I bought pex fittings and rings from pexsupply and figured I would just rent the crimper and buy the pipe locally. Is this a bad idea? Do I need to use the same...