Search results

My in-laws have a hub in their floor that was a floor drain (see attached photo). The hub is 4" inside diameter and I'm trying to transition with PVC to turn the floor drain into a shower drain. I cannot seem to find anything that will work (I was thinking of maybe using a flush bushing but I...

If I install my basement toilet near (within 4 feet) the lateral drain that leaves my home (not sure if it is 3" or 4" cast iron) do I have to have a seperate vent? The main stack is approximately 15 feet away from the area I would like to place the toilet. the I'm not quite sure what code says...

I have seen it mentioned that a vent can be run horizontal. I have a basement bathroom and I'm planning to have a sink and shower on one side and a washing machine on the other and a toilet that is wet vent from the washing machine. I cannot run the vent on the sink and shower side of the room...

Hello, If someone could answer the following question for me it would be appreciated. And the units I am using are from the UPC. If I have a 2" vent that can serve a total of 24 FU can I split the fixtures on opposite sides of the room into 1.5" vents (as long as each side doesn't exceed 8...

I have a shower on the first floor and I am going to remodel my laundry room in the basement into a bathroom/laundry room. The shower on the first floor isn't properly vented so I am wondering if I can include it in the basement remodel since I can access it from underneath. I was wondering...

Hello, I have a basement floor drain that is 12" center from the wall. I would like to utilize it as a shower drain since it is already in the floor. The drain is a cast iron (i believe) 8" diameter drain that necks down to 2" or 1.5" from what I can tell. My question is: Is it acceptable...

Hello, I am starting a basement remodel and am in the stages of planning the plumbing for a laundry room/bathroom. I am sure I will have many questions and this forum has been very helpful so far. Attached is a drawing of what I would like to do and I am not sure if there are any issues with...