Search results

Is there a chrome or brass tube that I can simply slide over the abs pipe coming out of the wall so that it doesn't look so utilitarian behind my pedestal sink? It's a new install but the wall is already finished and the pipe is sticking out of the wall.

How's it done? The instructions have the dw drain going straight into the plumbing, no air gap. Can it be run similar to a clothes washer drain, where the output of the dw is hooked over the edge of a drain pipe angled out of the wall with a P-trap at the bottom? What are my options? This is a...

I want to install a hot water dispenser with the input coming from an RO system. (RO system has an artesian filter on the output, so I don't expect to have an issue with agressive water deteriorating parts prematurely.) The hot water dispenser (Insinkerator HC-Wave) states 30-125 psi input, and...

I just gradeded the DWV under the half of the house that is receiving a major remodel. Apparently the main stack wasn't set deep enough originally to accomodate the all the necessary DWV bends for the toilet about 30' from the stack. Parts of the original run were graded level or negative...

I am remodeling my single story house with raised foundation. My house is 40 ft wide with a foundation wall every ten feet to hold the floor joists. The main stack goes through two of these walls to receive waste. The second wall apparently was repaired around the stack because the stack seems...

I have a project to complete, plumbing a shower wall with a temperature control valve, two volume control valves, a ceiling mounted rain-shower and a massage body spray on one valve and a double shower head on the other valve. I have two basic general questions regarding plumbing. Obviously...

I bought a Toto that has a 12" rough-in. Does this mean 12" from the finished wall to the center of the toilet flange? How much clearance should this give me from the back edge of the tank/lid to the finished wall? Michael