Search results

  1. jafriede

    Morton Water Softners any good?

    My Mother has had a year long nightmare with a NOVO 485HE-100 water softener that was installed by a local plumber. From the very beginning it would regenerate as needed without regards to the time of day even though it was set not to. The worst part though is that when regenerating while...
  2. jafriede

    Vibration when shower on

    I just put a new cartridge in my Delta single handle shower faucet (1300 series I think). I changed it with a replacement cartridge made by "Danco" that was bought at a big box store. After the job was done I tested it and everything seemed fine. While my daughter was taking the first real...
  3. jafriede

    Cadet 3 tank problems

    I have installed 2 Cadet 3 toilets in the past with no problems and have been very happy with their performance. Moved into a new house about a year and a half ago and decided to change the 1997 Gerbers that clog at least 3 times a week. I bought the Cadet's from a local plumbing wholesaler in...
  4. jafriede

    Shroud around flush valve???

    The Gerber toilets in my new 1997 house have a shroud in the tank surrounding the flush valve. It basically looks like a coffee can. When you flush, the water on the inside of the "can" goes down through the flush valve and the water outside seems to just stay there. I have never seen anything...
  5. jafriede

    Intermittant floor drain clog

    Please forgive the long story. Just want to get all the info out..... My basement has a toilet, two floor drains, and a drain pipe for the washer. They all converge (at one point I assume) into the main stack. One of the floor drains has a shower stall over it. In the past I have had to...
  6. jafriede

    Pex Methods

    I am going to be installing a water softener in a house I'm buying and will need to re-route some things. I am thinking of using Pex. I found a video on YouTube that showed 6 different methods of putting on ends. The two I'm considering are the crimp ring or the banding clamp. Which is the...
  7. jafriede

    Mansfield with trap hole in front

    I have a Mansfield toilet in my basement (on a concrete floor) that has the hole for the trap way on the front of the bowl instead of the rear like most toilets. It works fine, but I am assuming it's original to the house which was built in 1964. I have changed few toilets myself and usually...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks