Search results

Can't you run vents below slab as long as they are not truely horizontal and slope 1/4" per foot. That what I was going to run for mine. Is this correct?

What about the no hub fitting? Should I bury it or have an access bix for it?

Thanks for the advice. (1) So, I can't tie the 3 vents together below slab and then run up the single vent pipe? If not, can I tie the shower and the floor drain below slab then run up a single vent pipe? (2) Should I leave the two no hub fittings below the slab and fill in with...

Thanks for the advice. I am going to redo it getting rid of the horizontal double T-Y. I realize this after I saw water streaming across and coming up the other end of the Y. I received previous advice saying it was "ok" to do. I am going to finish this. (1) I am going to remove the...

I want to use one P Trap for my shower and floor drain for a basement bathroom. Would this work? Also, I have a 3" double wye. Should I replace this and use two single wyes? I wold have to put a toilet, shower, and drain on one line. Any help would be appreciated.

The pipe connecting to the outside was "out of round", so I could not get a regular coupling on it. The piping lying around were for dry fitting the pieces together.

I am adding a basement bathroom and connecting to the the existing ABS DWV system. I took out the concrete and dug up the lines and attached the new lines for the toilet, drain, sink, and shower drain. I cut the main line that leads outside to the septic system. It was a close cut under the...