Search results

In the process of replacing my S-trap in a very old summer camp, the 1-1/4 brass and chrome tubing that the drain consists of came loose where it goes down into a joint flush with the wood floor. (Vibrations from sawing it partway up.)Looks like a lead joint and lead is now cracked. Pic...

The sight glass on my old galvanized pressure tank is so dirty that it's hard to see through, and the seals leak for a couple of weeks in the spring when I bring water into the system. (I drain everything for the winter at my camp.) Is the sight glass likely to break if I try to take it out...

I have an old galvanized pressure tank at our summer camp, where we drain the water each winter. What kind of sealing set-up am I likely to have on the sight glass, which is leaking at the bottom seal? I've been reluctant to get into this for fear of breaking the sight glass or having trouble...

I have an old SS sink unit, and on one side there is a larger than standard drain basket, probably as a replacement for a waste grinder. I'm trying to find a strainer of any type that will work in this basket. I'm also curious as to what the basket originally came from, since no plumbing...

I had to take out the suction pipe to my Sears shallow well pump, and the previous connection had been done with thread compund instead of teflon tape, so there's a lot of residue of thread compound in the female threads in the plastic pump body. Aside from doing the best I can with a...

The TOTO toilet came with a cone washer and compression nut. Can I just run my PEX through that and tighten onto the threaded bottom of the flush valve? Or do I need to use one of the adapters that puts the cone washer onto a brass connector that goes through the compression nut, and then...

I have a flexible faucet hose with a 1/2 FIP connector. Can I connect this to a 1/2 male thread, such as on a male nipple. That's what comes out of the ball valve for the cold water supply. The threads seem right and the rubber gasket would seem to seal against the end of the nipple, which...

I'd like to try unscrewing a section of 1-1/2 inch galvanized pipe from a vent line inside a wall, but not if there is a high risk that it will break off at the threads where it goes into a heavy, probably cast iron, elbow up in the wall, as that would make the reconnection of the new vent...

I have an old (circa 1952) motor jet pump system. Motor rotates freely by hand. Replaced two starting capacitors and thought that would fix the problem. All I get is a buzz, and sometimes very slight movement in the shaft. This is a Fairbanks Morse 1HP motor operating on 220. Access to the...