Search results

I am going to get the Moen Kingsley shower system that will have four body sprays in addition to the shower head. Any preferences on a valve that you sweat copper or a valve that has screw in connections. Once I get past the rough in valve, I will use pex and shark bites. I have had...

I am putting a new hardwood floor in my bathroom... i had to put down 5/8" underlayment and then 5/8" hardwood... so now I am 1 1/8 inches higher.. that's not quite true... i removed a tile floor... is there a recommendation to make the toilet fit... the old flange appears ok...but the...

I am looking at replacing some double hung windows I know I want wood interiors..but I am debating over the exterior cladding vinyl or aluminum? I live in Greenville, South Carolina.

I have a gas hot water heater in my basement. I have been in the house for two years. The hot water heater is probably 5-7 years old. In the past three months or so, the pressure relief valve has released water 4 times. Recently, I turned the temperature down a bit, but it just...

in my haste, i neglected to hook up a separate grounding wire after I installed a whirlpool tub in my bathroom the motor and heater are on separate circuits and each is hooked up to a GFCI circuit breaker at the box Are we in any imminent danger not having the ground wire hooked up from...

Not too long ago, I used you folks for a question on providing power to a light switch/fan, etc. That is all worked out. Previously this switch was on the outside of an enclosed shower. Now I have blown out the shower and putting in a tub/shower combo with a shower curtain. Should I...

I had a bathroom ceiling fan on a switch. i replaced the fan and hooked it up to a new switch -- with two off and on's on one post please forgive my electrical ignorance. i want to run a separate light fixture off the second switch... so i ran the wire from the switch to the light...

I am installing a bathtub. the drain is brass. The downpipe is brass. Two issues: 1. What do I use to connect the brass to PVC? Can I use a 22.5 fitting as on offset on the downpipe to avoid a joist? I really don't want to notch the joist. Actually I would use the 22 attach...

I am re-doing a bath.... tore the walls down to the studs. I will have to post a picture shortly.... Right now I have 1/2 inch copper h/c into the existing valve... it's all soldered in. I will cut that out. The new valve is part of an American Standard Standard collection tub/shower...