Search results

Thanks, I'll wait on my project then and visit my local plumbing supplier tomorrow and ask about what you mention. Hopefully they have what you are referring to and this is common enough there is a good solution.

Hi, After replacing some rotten subfloor and new cement board, I was laying out my tile, cut the hole, and dry fitting my flange on top of the tile as I've read is the proper method. My concern is now that the flange will be sitting higher than it was orignally installed (which was flush on...

Hi, I'm about to cut the hole in my tile to install the closet flange in the link below. If you look on the photo of the bottom side at the black lip/ledge section right next to the steel ring. (I've also attached a photo) Does the hole need to be big enough so this black plastic part sits...