Jarniscipus
Member
I am relocating my well plumbing in the pic below to free up some needed space....and had a few questions about the setup.
1. The pressure sensor below - is there any reason this sensor has to be horizontal or can I place it on a vertical pipe?
2. Gauge - I can place the gauge on a vertical pipe right?
3. My house is all copper and brass, the well plumbing below is PVC - any reason why it is a good or bad idea to use PVC in this setup or does it matter? Should i redo this in brass and copper when I move it?
4. There are 2 hose bibs coming off of a T - why are there 2 hose bibs, is this a code requirement and can I only reduce it to 1 hose bib? I don't understand why the well company installed 2 bibs there.
Many thanks as always!!!
1. The pressure sensor below - is there any reason this sensor has to be horizontal or can I place it on a vertical pipe?
2. Gauge - I can place the gauge on a vertical pipe right?
3. My house is all copper and brass, the well plumbing below is PVC - any reason why it is a good or bad idea to use PVC in this setup or does it matter? Should i redo this in brass and copper when I move it?
4. There are 2 hose bibs coming off of a T - why are there 2 hose bibs, is this a code requirement and can I only reduce it to 1 hose bib? I don't understand why the well company installed 2 bibs there.
Many thanks as always!!!