Recent content by Steveo

Appreciate you taking a look! After I tightened up the compression nut I wondered if that would have been a bit better. But it isn't leaking and so far so good - so not gonna fix what isn't broken. Sometimes my "fixes" are worse than just leaving it alone ... learning to just leave it alone...

Thank you sir!

Thanks! I had thought about that but I had a hell of a time getting the compression fitting to sit and not leak so I’m more than a little hesitant to try and move it. Unless it’s necessary to prevent a catastrophic failure in the future I probably shouldn’t test my luck!

Old angle valve failed so I had to replace it and needed to replace the supply line as well - the old supply line was part of the valve. First time doing any of this kind of work and wondering if the supply line I installed is the wrong length. I had to put a lot of pressure on the line to make...