Recent content by sprink

You were correct it was the faucet. It was the valve that supplies the spray head and the faucet. The valve was not opening fully to the faucet which explains why the spray seemed to be fine. The aerator was the first thing I checked in the old faucet and in the new one I ditched the water...

Yes, I installed the faucet and no dope was needed. This was an existing problem which prompted the faucet replacement. What I mean by open and close is opening and closing the angle stops. That was suggested by a plumber at work and also to check that the valve was fully open at the street...

No, but I've inspected the hoses and I opened and closed the angle stops several times which was another suggestion. Since I moved in I've had bad flow at that sink. I replaced the faucet, installed a hot circ pump, checked the regulator, checked the valve at the street, tested the water...

I have good water pressure but bad flow at my kitchen sink. I've checked all the obvious, replaced the faucet and still have not solved the problem. Plus the water only gets luke warm after a half hour of running with a hot water cirrculator. Where do I go next?