Recent content by RenoChris

If it's hidden and untouched, than yeah. If you've gutted the first floor, and adding a second, won't you have to connect into the stack and vent in the first floor? That's the part I'd replace.

Yes, you can run in the floor joist, if it runs that way, or create a bulk-head (soffit) to run them in as well... Also, if you're gutting the first floor, I'd get rid of the cast iron and replace it all. You've gone that far... don't leave that old stuff in there. It's a pain to tie into the...

Assuming the vent is between the shower and the tub drain, then the tub isn't vented. And a lav always has to be vented in the wall behind the sink, it can't go vertical unless it is vented there. Actually, the tub and shower can't drain vertically either, unless it is vented at that turn...

Correct - if they are individually vented, they're not wet vents. My second portion there was (hopefully) how I think some places actually use a wet vent to do all three fixtures with one 2" vent. I don't know if it's code in Canada, I've never done it. But, the lav would drain into the shower...

Well, do you mean, is 2" big enough? Yes. But, if they're indivdually vented, you'll have 3 vents that would tie in together 42" above the floor into a 2" vent. Or, do you mean, can you wet vent all three with one 2" vent? Here's how I understand it... Basically, vent the toilet 2"...

Thanks guys. I do remember reading about that. I didn't find that table in the code... I guess they updated it... But I did find this: (a) the developed length of a fixture drain measured from the trap weir is (i) not less than twice the pipe size of the fixture drain , and (ii) not...

I've been reading that the max length of a shower trap arm is 60" before the vent. I'm assuming this is a standard 2" drain and trap. If so, I was under the impression that a 2" trap could be 8 feet before vent (2" drop). I checked the provincial codes (Canada) and there's nothing specific...