Recent content by DeereAdam

Hi Everyone, I am replacing an old toilet with a wall hung unit due to the location. Going to a wall hung unit allows the bathroom to work much better. Now I need to abandon the old toilet flange and properly seal the cast iron pipe. I will tile over this once it is properly seals off...

Thank you Terry!

Hi Everyone, I am plumbing a 3 bathrooms and a kitchen. Any thoughts on the best shutoff valves for sinks / toilets? 1/4 Turn or Multi-Turn? Are hammer arrestors required for 1/4 shutoffs? Also, planning to run PEX (A) and use copper stubs with strap plates... Is this the best (most...

Awesome... that is the information I was looking for. At least I know my constraints now. I really appreciate your help Terry and Michael!

Will a gravity flush toilet flush properly with a similar setup (immediately horizontal)? Toto Aquia Toilet on Grohe Carrier.

I don't have room for any of that... I posted a picture for a better view of the situation. I have seen toilet carriers with horizontal discharge... but this may be for pressure assisted toilets???

Please excuse the poor mock-up... This is the situation I have... The sanitary tee is the location of the main stack. Note the angle of the drain from the toilet carrier.

Hi, I am installing a wall hung toilet in my basement. The existing main stack is several feet away. To install the toilet where I'd like, the toilet drain will need to run horizontal (nominal fall) to the main stack. Question is, will the toilet flush properly with the drain exiting the...