Recent content by 3m

Not planning on a swimming pool at this time maybe later, Going to cover inside with 7/16 osb board unpainted, I will end up with 5" of blown in insulation. Thanks for the reply

Built new shop 36 x 45 x14 tall, looking for ideas on the insulation, was thinking of 1 1/2 inch styrofoam against exterior metal siding with blown in insulation filling remainder of the cavity. Is it better to leave gap at metal siding for ventilation and to rid wall of any water vapor

If you installed a pressure balancing valve and havent turned the hot water supply on the valve will shut off the flow of water completly. But they will sometimes allow a small amount of water thru. Or you may have a bad cartridge

Redwood Maybe they all think they are big D&^KS

Who said you need to install it. the building inspector ?

What size generator do you have, and what are you planning on running with it

Suck it up and call an electrician before the house burns down

The tab is to hold onto it while you smack it with a hammer to keep it from dropping into the drain. I usually take a flat screwdriver and start it breaking then lightly tap it with a hammer all the way around

I would be looking for empty beer cans stuffed in the wall or heat register, because this guy was either drunk, stoned or blind. After seeing these pictures Im going to raise my prices for the high quality of work that i do

Whats the measurement from the studs to the center of the drain, its hard to judge but it doesnt like like its right going by the picture

I would ask the plumber to make the repairs needed to replace anything that was damaged, This is why they require licensed contractors to carry liability insurance, to protect the homeowner.

yes and yes

I failed an inspection for the very same reason, when I questioned the inspector on this He stated I know you guys have been doing it this way for ever but now they require a 16 inch long plate with 8 16 penny nails on each side. This is to keep the top plates from pulling apart, if the house...

What kind of furnance do you have gas or electric

where is the line going to