(206) 949-5683, Top Rated Plumber, Seattle

All Blog Entries

  1. firefighter

    I have a shower in my basement which has a concrete floor. I tore out the shower stall and now am trying to replace the drain which has lead around the PVC pipe. I have tried everything to remove the lead without breaking the plactic pipe. Any ideas would be helpful
    Categories
    Uncategorized
  2. Which Latex Primer works best with drywall mud compound for a Kerdi installation.

    Post(s) deleted by John Whipple

    Updated 03-18-2014 at 08:47 AM by johnfrwhipple

    Categories
    Bathroom Waterproofing
  3. Flange too High?

    I'm in the process of installing a new Drake CST744S toilet. A new floor was installed leaving the original flange 1/34" below finished floor. I reworked the flange to try to get it level with the floor, however, it ended up just slightly too high, about 1/16". When I place the toilet on the flange/floor it just about fits level, but rocks just ever so slightly. A couple of shims with get it level. Since the "Drake" only has a 3/4" lip it doesn't give any extra room ...
    Categories
    Uncategorized
  4. Automatic water circulation

    Hi I have hot water baseboard heat with a tankless water heater. The hot water automatically circulates through the heating loop without the pump running. I've had this problem before and had to use a zone valve to remedy the problem. Is there a cheaper solution to this problem?
    Thanks
    Categories
    Uncategorized
  5. Water is salty after reffilling softner!Help?

    Quote Originally Posted by rjh2o View Post
    What brand of softener is it? Some manufacturers have refill as the initial cycle (dry storage) as opposed to the last cycle (wet storage).
    RJ
    I'm having the same problem in my Kenmore softener. It keeps regenerating and not removing the water from the tank.
    Categories
    Uncategorized