View Full Version : drilling faucet holes in..
12-11-2004, 06:52 AM
The top side of the American Standard Caddet 5' whirlpool. I was hoping :confused: to have deck mount but not sure how to drill tub without the chance of cracking the tub, any info helpfull
Dave (not the plumber guy)
12-11-2004, 09:50 AM
If the tub is acylic, you can use a hole saw (http://www.lenoxsaw.com/aholesaw.htm).
Most handles can use the 1 3/8" bit, the tub spout may need a smaller bit size.
Be sure that the point where you drill the holes is reinforced for mounting the faucet.
12-11-2004, 01:15 PM
Another thing that doesn't hurt is to use some masking tape on the tub - it marks eaiser and helps to keep the drill center in place. In fact, you may want to drill a pilot hole prior to using the hole saw - still use the masking tape. It also can help to keep the edges from chipping.