PDA

View Full Version : Toilet Rough In Problem(?)



leesburg_dave
02-02-2006, 07:05 PM
Hello. I am installing a bathroom in the unfinished part of my basement. The builder installed rough-ins using 4" PVC for the W/C. The builder's floor plan, when looking at the fixtures is like this: Left wall, 48" vanity cabinet, W/C, tub/shower. The bathroom size is 112" wide and 60" deep. Center of this PVC to the new framing will be 12-1/2" (I think I'm OK there?) and the center of this pipe to the edge of the bathtub will be 17". So far so good. Here's my question: We bought a 48" wide vanity base cabinet and a 49" wide piece of granite for the top. The distance from the vanity base cabinet side to the center of the pipe is 15" (and that's taking into account the finished wall on the left side of the cabinet). However, when you place the granite vanity top in place, it hangs over 1" on the right side. Does this cause a code violation or do they measure from the vanity base cabinet side to the toilet? Thanks in advance.

David

hj
02-03-2006, 05:19 AM
They do not usually measure it. The look at it and if it looks like it is too close then they measure it. You should have no problem.