Toilet Rough In for the Furture

Chefwong · May 11, 2013

I think I'm leaning on the UltramMax II but may go with the Vespin. Need to see them in person...

However, the walls are going to be tiles so I would like to RO the water supply for a skirted toilet should I do that in the future.
Based on past posts , 5.5 off center seems to be the sweet spot.
Height ?

Jadnashua · May 11, 2013

chefwong said:
I think I'm leaning on the UltramMax II but may go with the Vespin. Need to see them in person...

However, the walls are going to be tiles so I would like to RO the water supply for a skirted toilet should I do that in the future.
Based on past posts , 5.5 off center seems to be the sweet spot.
Height ?

It's all diagramed in the spec sheet...use those dimensions, and you are sure it will work. While you can get by with less, just use the spec sheet, readily available at the Toto website.

Sponsor · 2022-01-29T12:20:58-0800

Terry · May 12, 2013

If you are roughing for a skirted bowl, then rough at 7" or 8"
6" will work, but it's snug.

The non-skirted can be as tight as 3"
So........between 6 and 8 is good.
Or anywhere that you don't hit the back of the bowl.

Chefwong · May 12, 2013

Thanks TD. I'd rather have it out enough that I won't need to cut tile....ad relocate down the road

Toilet Rough In for the Furture

Users who are viewing this thread

Chefwong

Member

Jadnashua

Retired Defense Industry Engineer xxx

Sponsor

Paid Advertisement

Terry

The Plumbing Wizard

Chefwong

Member

Similar threads