MBrown
New Member
- Messages
- 5
- Reaction score
- 0
- Points
- 0
OK, here's the situation:
My two overly rambunctious cats knocked over a stepladder in the utility room. The ladder fell over and was stopped by...the gas pipe leading to the furnace.
The gas pipe hangs down from a 90-degree joint that is anchored to the floor joist above. When the ladder hit the pipe, the horizontal part of the 90-degree joint rotated on the pipe threads, knocking the pipe out of alignment. I slowly moved the pipe back into position and dripped soapy water (as best as I could) on top of the joint to see if there were leaks. As far as I can tell, there are none. I also don't smell gas (but that may not mean much).
My question is, should gas pipe joints be rigid? Or should they be as flexible as these, allowing the pipe to rotate easily along its threads? (The yellow flextube from the valve to the furnace was fine.)
Do you recommend that I have a plumber replace the gas line joint?
P.S. I've moved the stepladder, but had to keep the cats.
Thanks!!
My two overly rambunctious cats knocked over a stepladder in the utility room. The ladder fell over and was stopped by...the gas pipe leading to the furnace.
The gas pipe hangs down from a 90-degree joint that is anchored to the floor joist above. When the ladder hit the pipe, the horizontal part of the 90-degree joint rotated on the pipe threads, knocking the pipe out of alignment. I slowly moved the pipe back into position and dripped soapy water (as best as I could) on top of the joint to see if there were leaks. As far as I can tell, there are none. I also don't smell gas (but that may not mean much).
My question is, should gas pipe joints be rigid? Or should they be as flexible as these, allowing the pipe to rotate easily along its threads? (The yellow flextube from the valve to the furnace was fine.)
Do you recommend that I have a plumber replace the gas line joint?
P.S. I've moved the stepladder, but had to keep the cats.
Thanks!!