another sink question

[wardair]

sorry forgot to ask this last time

ok first the sink is finally in i was going to mount the sprayer on the counter but i was wondering and i tried with the old sink after i took it out is it possible to drill a hole in the new aycrlic sink to accommadate the sprayer or will it weaken the sink

thanks again

[jimbo]

This is done all the time. Very easy to do on an acrylic sink. Get a good hole-saw bit of the specified size. Drill from the top. Masking tape applied across the location will help to minimize any possible chipping of the acrylic top coat.

[sulconst2]

if its acrylic then its same as tub material. yes, drilled many a tub to set faucets. tape the area with blue tape then use a guided hole saw on slow speed with low pressure.

[wardair]

thanks

thats what i thought just needed some reassureance about the strenght of the sink

[sulconst2]

jimbo,
we did it again. same answer at the same time! :D

[wardair]

ok drilled the hole with ease

thanks again guys

now to clean up the kitchen