AQBill
New Member
Dear Friends, I'll bet this isn't an uncommon problem. When the house I live in was built, the toilet flanges were set into the floor assuming that 1/2 inch tiles were to be used to finish the bathroom floors. However, the owners - probably running low on money - put in 1/8 inch composite tiles instead. The end result is that the flanges are 3/8 inch too high. Does anyone make some kind of spacer/pedestal that raise the floor enough so the toilet will sit flush?
Any thoughts will be welcomed. I've replaced two of four toilets and have done the best I can with shims...but the gap between the floor and the toilet is noticeable.
Many thanks
Any thoughts will be welcomed. I've replaced two of four toilets and have done the best I can with shims...but the gap between the floor and the toilet is noticeable.
Many thanks