I installed some new cabinets and forgot to notch the bottoms to route the drain like the previous cabs were done. The old drain line ran along the floor about 3', took a right hand turn, then about 2' over into sink cabinet. It then went to a high loop and into the dw tail piece.
I was hoping to be able to drop this through the floor, over to sink base, then back up into a high loop. The counter tops on on, so trying to route under the cabs is not an option.
Any info would be greatly appreciated.
thanks
I was hoping to be able to drop this through the floor, over to sink base, then back up into a high loop. The counter tops on on, so trying to route under the cabs is not an option.
Any info would be greatly appreciated.
thanks