mitchke
New Member
Hey,
I installed a Clack WS1 metered about 18 months ago, total new system. has worked flawlessly till now. noticed several days ago that water was hard, checked and it is not metering. Display says there are 800 gallons left (which is what it starts at after a cycle). checked simple stuff (plugs are all secure on the control board, no broken wires, the meter turbine is clean and spins freely). since it is stuck reading 800, is this more likely a control board problem? is there an easy way for a DIYer to check?
thanks
Keith
I installed a Clack WS1 metered about 18 months ago, total new system. has worked flawlessly till now. noticed several days ago that water was hard, checked and it is not metering. Display says there are 800 gallons left (which is what it starts at after a cycle). checked simple stuff (plugs are all secure on the control board, no broken wires, the meter turbine is clean and spins freely). since it is stuck reading 800, is this more likely a control board problem? is there an easy way for a DIYer to check?
thanks
Keith