I'm trying to install a vacuity toilet. On the back of the bowl there is a raised "bar", such that the tank, when tightened down completely, is not level. It leans forward.
If I can manage to insert this image, here is what it looks like from the side:
https://terrylove.com/forums/attachment.php?attachmentid=356&stc=1
The tank is already resting on the "bar" even before tightening:
https://terrylove.com/forums/attachment.php?attachmentid=357&stc=1
Here's the bottom of the tank:
When I tighten the tank bolts, the larger foam seal gets compressed and I've got the leaning toilet of Pisa. If I don't tighten it that much, it leaks. Any suggestions? I've been thinking of trying to grind down the bar on the back of the bowl a few mm, but I'm not sure how to (or if I can) do that.
Thanks a bunch!
If I can manage to insert this image, here is what it looks like from the side:
https://terrylove.com/forums/attachment.php?attachmentid=356&stc=1
The tank is already resting on the "bar" even before tightening:
https://terrylove.com/forums/attachment.php?attachmentid=357&stc=1
Here's the bottom of the tank:
When I tighten the tank bolts, the larger foam seal gets compressed and I've got the leaning toilet of Pisa. If I don't tighten it that much, it leaks. Any suggestions? I've been thinking of trying to grind down the bar on the back of the bowl a few mm, but I'm not sure how to (or if I can) do that.
Thanks a bunch!
Attachments
Last edited: