About 5 years ago I installed a Toto/Drake toilet in our main bathroom. It has worked flawlessly although the flush has always been a little noisey. Recently the Gmax valve seems to have developed a problem. After flushing it may be 20 seconds or so before the valve lets water start flowing into the tank. Has anyone encountered this problem or know the cause of it? This "problem" is something we can live with but my concern is that eventually the delay may get longer until it no longer allows water into the tank.
Gmax in Toto/Drake
- Thread starter Timmy
- Start date
Jadnashua
Retired Defense Industry Engineer xxx
Simple answer, leave it alone. Might work - take the cap off, remove the filter, and clean to see if there's anything in there. Long term, go to a plumbing store or Lowes and buy a new cap assembly for a few bucks and replace it. Instructions are on the package. Should take all of a couple of minutes. That toilet (probably) uses the Korky valve.
www.terrylove.com/korky
www.terrylove.com/korky
Last edited by a moderator:
Similar threads
