Rmelo99
Network Engineer
When I did the drain lines for my 2nd floor bath sinks I used 2" pvc. I also used 2" tees. Now that I'm getting ready to connect the sinks I have to figure out the best approach since bath lavs use 1.25" drains
Do they make a 2" to 1.25" trap adapter so I can go right into the tee with the trap and not use a bushing?
Should I use a 1.5" trap and then just go down to 1.25" at the trap to sink tailpiece?
Thanks
Rem
Do they make a 2" to 1.25" trap adapter so I can go right into the tee with the trap and not use a bushing?
Should I use a 1.5" trap and then just go down to 1.25" at the trap to sink tailpiece?
Thanks
Rem