Angled bowl to tank.

Hi my question I have small bathroom. original toilet finally broke after 33 years. actual measure length from wall to front of unit was 26-3/4 inches !
Am trying to replace with elongated or compact elongated bowl that would have tank parallel with wall 'BUT' bowl would be at 40 to 45 degree angle to tank!!!!! Corner toilet does not fit "tank to wide" so who,how,where, do I contact to make this happen.
It doesn't seem to hard of a problem if someone could drill another hole in procelean bowl seat where tank meets bowl.
Have you ever heard of this slight modification. thanks
Ray

There are pros on this forum that have been around since flush toilets were invented, maybe one of them can give you so hope, but I serious doubt that this is a doable thing. Can you attach a photo or drawing that will show us just why you need a toilet that does not conform to a normal room design?