Activity Stream

I was a Playboy Bunny, Flight Attendant and Singer/Dancer in a band in Vegas -- but I'm not a "shill for Kroil"

wiring hasnt been fooled with in the 5 yrs or more . It has its original pumptec and trip box. The 1-1.5HP. The 2HP I picked up as a parts item...

Thanks for the thoughts everyone! I will take a look at the slope, replace the washers/etc., and see if I can try a more involved fall-time shut down...

Time to get out the amp probe and find the problem. With the looks of that connection, The connection was loose or the motor is drawing to much...

I got the fan in today, but have to finish up the ductwork in the morning. There appears to be enough room in the attic, so I think I'll be blowing...

FOr $100 in parts, I almost think it may be worth getting a new valve that meets current anti-scald regulations. While you can repair that 50+ year...

I would install a new stud right next to the bad one, or for a belt and suspenders approach, a new stud on each side of the bad one.

You can count me as one of the plumbers that likes the Symmons Temptrol... The only time I would not recommend one is when you have water quality...

American Standard "push/pull" faucet. Do an internet search and you will find the repair kit. It usually in the $100.00 range. Getting the parts is...

quote; What hj doesn't mention is how hard it is to lift a tub that has blocking around it. Lift it????? I have NEVER 'lifted' a cast iron, or any...

The shaft of any (that I'm aware of anyway) frost-free hosebib must be installed with a slight slope towards the outside, or water can pool inside...

Is it possible that they silicone the gasket in place? IF so, it's a bear to remove.

I'd concur with Terry that platform perhaps 3" high that your wife's feet could rest on may be a solution. I don't think even if you can locate a...

How's the 154 vs the 114 as far as comfort? Any thoughts on the s350e? Is it a "higher ride"? Rob

Ok done! but it still trips. i tightened all other connections

I own a condo in Chicago that has individual room units...PTAC...they are all older units and am looking to replace a couple. The problem is, they...

The SS114 is pretty low as far as seats go. You may want to look at something that the fit can be on ...

In the Posi-Temp, You pull the clip, pull the cartridge out and reinsert it upside down. That reverses it. In the old Moen's, you would simply spin...

It will be an interesting story when you are done. What hj doesn't mention is how hard it is to lift a tub that has blocking around it. It's real...

That's what I thought ,and thanks for your response .

My point is that if your daytime water pressure is at 80psi, and you don't leave a peak reading gauge on it overnight, you have no idea what the...

The heat exchanger in the indirect may have a pinhole leak in it allowing the potable water to leak into the lower pressure boiler loop. If that's...

I had my well water tested by a certified EPA lab and it came back as negative for Total coliform bacteria

That is what I would do. PRV on the Input to the House. Chances are, You can use the California Flow Regulating Washer Discs for the rest of the...