Activity Stream

Ok so it doesn't sound like the well caved in or anything?

This "vent" isn't clear enough?

Thanks for the report. Sounds like both the merchant and Toto are responding well to the problem and neither is trying to pass the buck to the other...

I was in the same situation as you. I now have a 1200sqft cape which is fully insulated and renovated with an Alpine 150 boiler. Don't fall into the...

I sent pictures to Toto USA and they said the tank should be covered under the 1 year warranty. The online merchant has sent me a replacement tank...

Mostly, yes. User hj said, "The 2" pipe could either be a vent for the bathtub trap, or the opening to the trap" -- hence, the new picture which I...

As for the hole... I know nothing about pumps that go in basements. But after reading about what the difference is and seeing that the pipes all...

Big old cast iron radiators are GREAT for gas-fired modulating condensing boilers- FAR better than fin-tube base board for two reasons: They put out...

C is the vent for the tub, and the pipe extending horizontally is the trap arm before the p-trap is glued on. We always install the trap "after" the...

The Flotec pumps are not known for their quality or longetivity. Let us know how that works out for you.

In my opinion, If you have been accustomed to grilling on grills with a never-ending supply of natural gas (so long as gas bill is paid), you will...

A. A rarity. Or, a Vitra.

YOr picture is too poor for us to tell anything about pipe "C", other than if it is connected to any of the drain lines it points to, without a turn,...

next day thursday Today's Update on my pumptec/tripping ,for better clarification if needed I left the trip switch in the tripped position for...

Kerdi Fix is the Bomb. I think from experience it cures more like 1/8" per day. We can leave KErdi Fix out overnight and then just pull the...

I recently moved into a house that has a K3402PB toilet. It started running, so I read up online about getting a replacement flapper. I ended up...

Looking at your photo, I don't see any reason why the Korky 528 fill valve (THIS ONE) couldn't also fit in there; it's easier to install. However,...

IN a typical bathroom, the only fixtures that don't normally have separate shutoffs are those in the tub/shower, so while shutting the entire room...

I had a similar intermittent tripping of a GFCI, and this was in the house, not outside subject to weather. The GFCI daisy-chained to 4 more...

well,i replaced the twist ant it worked fine. about 7 hours later I noticed it had triped off after or during the first pumping cycle after the...

Ok, I found the pictures of the pipe configuration before the slab was poured. Here are some... I am guessing, from what I've learned here,...

I think I would seal the top in plastic drop cloth to test it. This would only take a few minutes. Well this one is $70 on cl States it raises...

We're talking about shut offs on the risers - right before it feeds the bathroom for the full SUPPLY throughout it. Not a shower/tub valve...