Activity Stream

Yeah.... It's only about 30', I just don't know if I call pull out the existing 12 gauge UF without redigging the whole trench. I might try digging...

quote; remove the gator bite and sweat a 1/2 inch copper elbow Why not do it the "easy way" and just remove the stiffeners from both sides?

If pipe "A" is 6" from the center of the wall and pipe "B" is 9" behind it, that is 15" and gives you 12" for the toilet and 3" from the face of the...

That looks like a "J" next to the 1, not a 1/4. The valve appears to be marked 1", however.

J R Smith used to make 1 1/2" "sediment traps" for undersink use, but I don't see them in their current catalog. Wade, Zurn, or Josam probably still...

That or a small hacksaw are the about the only ways.

If they are ''air bubbles" then the valve is not shutting off tightly and the slight flow of water is aspirating air from the refill tube. BUT, there...

Thx Valveman Boy is it great the days are longer,still not enough time though. Although the dark burn spot you see on the twist cap has been there...

A shot in the dark: First, take the cover off the tank and make sure that the little hose from the fill valve to the flush valve is mounted above...

Lee, I really appreciate all the help so far!! There is a tee right after the main shutoff where the main comes into the house. One side of...

Jim is that just with Ardex like I was mentioning or is that with any thin set? I wonder if Ardex will raise the warranty to 15 years with Kerdi...

Check to see if you are getting water hammer, perhaps from a bad checkvalve. That could make your pressure switch bounce.

Yes the two blacks are hot wires. You know it ran fine for years on just the two wires, so you can just cut off the green one. But it won't be up...

I see more problems with the cast iron ones than the plastic ones. The suction adapter rust up so bad the water cannot get into the pump. But I...

There is an obvious bad connection on one of those red, twist on, Scotch locks.

Make sure your pressure switch is not double bouncing on shut off.

Where are your outdoor spigots in all of this? But yes, bringing the incoming line all the way to the first fixture makes good sense. Yes, and...

You know, that just seems silly to me. The best (ground) you'll ever have is the well in which the pump is in. What possible good would running a...

I think that may be my best way to tackle this. What would be my best way to get down and around the pipe? I want to be careful not to break it...

Your answer lies in the next to last line in your post. "pull a new cable."

The cast Iron ones are OK, if you get one that Sears sells, You can get parts easy. The Plastic ones are junk.

FloTek is a 6 letter word for junk. Buy a Goulds that will last 20 years and be done with it.

The green wire is a ground. To be code compliant, you need to put in new 3 conductor wire and bond the green wire to the casing, well cap and to the...

Hi Gary, It seems to be better than before, but not the same as what I had before... I am currently using 12lbs setting with 0.25 BLFC, my salt...

My shows : 3356179-110912-0010 Is that means mine were build in 11/09/2012?